Barnett friction plates in the 850-style clutch hang off the mainshaft.
Your vehicle's flywheel is directly responsible for transferring power from the engine to the clutch of the transmission.
While it's warming up, just pull and release the clutch lever a lot, slowly. Your throw-out bearing presses directly against the clutches pressure plates, and if you don’t have a consistent and flush fitment, it’s going to make a ton of noises when you depress the clutch. Only 1/4 cup or so should drain out of the crankcase itself. After tearing apart the clutch, I realized the whole clutch needed to be replaced. Did you soak the plates in oil before installation as is recommended? Anyway I didn't and don't know if this could prevent the sticking. Honda TRX Parts & Accessories Best selection and great deals, for your Honda TRX. Crankshaft Coalition Wiki - hot rod tech articles Cleaned clutch plates a little too well? was created by the2012. After doing this my bike never lurches forward anymore. Using a propane torch get the cylinder (s)fairly hot. a better strategy is look ahead analyse the … a motorcycle grade (moly free for the clutch) 20w-50 JASO rated oil would be great dont use car oil. I don't know how long the clutch has been slipping so I'm going to replace the clutch plates, friction plates, springs, basket, et al, just to know exactly what I have and what condition.
How to unstick motorcycle clutch plates Oftentimes, a mildly stuck clutch will free up by just pulling the clutch in and revving a couple times before attempting engagement.